Knowledge Base: Citrix XenServer 6.x Doesn’t Boot After Installation
Citrix XenServer 6.x Doesn’t Boot After Installation
Document ID: SX123389
After a successful installation of XenServer 6.x, the XenServer doesn’t boot from the local Hard Drive
UEFI (Unified Extensible Firmware Interface) wasn’t built with legacy support enabled which is required by XenServer.
Boot from Legacy only. In order to do so follow these steps:
- Restart the server
- Enter to BIOS setup
- Go to: Boot Manager>Add Boot Option
These knowledge bases are provided by SmartX/ControlUP. Gain this same kind of visibility in your terminal services and VDI environments, check out ControlUP yourself!
To learn more and to read the entire article at its source, please refer to the following page, Citrix XenServer 6.x Doesn’t Boot After Installation